INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. INSTALL FRONT UPPER BALL JOINT |
Using SST and a press, press in a new upper ball joint.

- SST
- 09612-30012
09223-00010
Using a snap ring expander, install a new snap ring.
- NOTICE:
- Make sure the snap ring is securely installed in the groove.
| 2. INSTALL UPPER BALL JOINT DUST COVER |
Pack the upper arm ball joint with MP grease No. 2.

Text in Illustration *1
MP grease No. 2
- Grease capacity:
- 8.0 g (0.282 oz.)
Apply MP grease No. 2 to the locations shown in the illustration.
- NOTICE:
- Do not apply MP grease No. 2 to the tapered or threaded parts of the ball joint.
Install a new dust cover to the upper arm.
Install a new dust cover set ring.
| 3. INSTALL FRONT UPPER ARM BUSH |
Using SST and a press, press in a new upper arm bush.

- SST
- 09710-30021
(09710-03101)
| 4. TEMPORARILY INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY LH |
![]() ![]() |
Temporarily install the upper arm and 2 retainers with the bolt and nut.
Text in Illustration *1
Nut
- HINT:
- Fix the nut in place and temporarily install the bolt.
Install the upper arm to the steering knuckle with the nut.
- Torque:
- 110 N*m{ 1122 kgf*cm , 81 ft.*lbf }
Install a new clip.
| 5. CONNECT FRONT STABILIZER LINK ASSEMBLY LH |
Connect the stabilizer link to the steering knuckle with the nut.
- Torque:
- 70 N*m{ 714 kgf*cm , 52 ft.*lbf }
- HINT:
- If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
| 6. CONNECT FRONT SPEED SENSOR LH (w/ ABS) |
Install the 2 bolts and connect the speed sensor wire.
- Torque:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
| 7. INSTALL FRONT WHEEL |
Install the front wheel.
- Torque:
- 105 N*m{ 1071 kgf*cm , 77 ft.*lbf }
| 8. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 9. TIGHTEN FRONT UPPER SUSPENSION ARM ASSEMBLY LH |
Tighten the bolt of the upper arm.
- Torque:
- 115 N*m{ 1173 kgf*cm , 85 ft.*lbf }
- NOTICE:
- Do not tighten the nut.
| 10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |

