DISPOSAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY |
![]() ![]() |
Fully extend the shock absorber rod, and clamp it in a vise at an angle.
Using a drill or similar tool, gradually make a hole in area A to discharge the gas inside of the absorber.
- CAUTION:
- As metal debris may be blown outward by the gas, you must:
- Wear protective glasses.
- Wear protective glasses.
- Cover the area being cut.
- Cover the area being cut.
- NOTICE:
- The gas is colorless, odorless and harmless.


