2014 Hilux · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL REAR SHOCK ABSORBER ASSEMBLY

F050332E03
  1. Install the 2 washers to the axle housing.

  1. Install 4 new bushes to the absorber.

  1. Install the absorber (with the 4 bushes) to the U bolt seat and frame.

  1. Install the 2 washers.

  1. Temporarily tighten the 2 bolts.


2. INSTALL REAR WHEEL
  1. Install the wheel.

    Torque:
    152 N*m{ 1,550 kgf*cm , 112 ft.*lbf } for steel wheel
    121 N*m{ 1,234 kgf*cm , 89 ft.*lbf } for aluminum wheel


3. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.


4. TIGHTEN REAR SHOCK ABSORBER BOLT
  1. Tighten the 2 bolts.

    Torque:
    105 N*m{ 1,070 kgf*cm , 77 ft.*lbf }

← INSPECTION (from Jun 2011)DISPOSAL (from Jun 2011) →