2014 Hilux · Service Manual SUSPENSION & AXLE

DISPOSAL

Removal / installation · Vehicles built from Jun 2011


1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY

C113170E01
  1. Fully extend the shock absorber piston rod, and clamp it in a vise at an angle.

  1. Using a drill or similar tool, gradually make a hole in area A to discharge the gas inside of the absorber.

    CAUTION:
    As metal debris may be blown outward by the gas, you must:
    1. Wear protective glasses.
    1. Cover the area being cut.

    NOTICE:
    The gas is colorless, odorless and harmless.

← INSTALLATION (from Jun 2011)HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2011 – Oct 2011) →