2014 Hilux · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL REAR SHOCK ABSORBER ASSEMBLY

C113168
  1. Install the 2 washers to the axle housing.

  1. Install 4 new bushes to the absorber.

  1. Install the absorber (with the 4 bushes) to the U bolt seat and frame.

  1. Install the 2 washers.

  1. Temporarily tighten the 2 bolts.


2. INSTALL REAR WHEEL
  1. Install the wheel.

    Torque:
    105 N*m{ 1,070 kgf*cm , 77 ft.*lbf }


3. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.


4. TIGHTEN REAR SHOCK ABSORBER BOLT
  1. Tighten the 2 bolts.

    Torque:
    105 N*m{ 1,070 kgf*cm , 77 ft.*lbf }

← INSPECTION (from Jun 2011)DISPOSAL (from Jun 2011) →