REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. REMOVE REAR WHEEL |
| 2. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() ![]() |
Remove the bolt and disconnect the cable from the spring.
| 3. REMOVE REAR SHOCK ABSORBER ASSEMBLY |
![]() ![]() |
Support the rear axle housing.
Jack up and support the vehicle's frame on stands.
Lower the axle housing until the leaf spring tension is free, and maintain this position.
Remove the 2 bolts and 2 washers.
Disconnect the absorber (with the 4 bushes) from the U bolt seat and frame.
Remove the 4 bushes from the absorber.
Remove the 2 washers.
| 4. REMOVE REAR LEAF SPRING U BOLT |
![]() ![]() |
Remove the 4 nuts, 4 washers, 2 U bolts, spring bumper and U bolt seat.
| 5. REMOVE REAR LEAF SPRING PIN BOLT |
![]() ![]() |
Remove the nut, washer and pin bolt.
| 6. REMOVE LEAF SPRING SHACKLE INNER PLATE |
![]() ![]() |
Remove the 2 nuts, 2 washers and inner plate.
| 7. REMOVE NO. 2 REAR LEAF SPRING SHACKLE SUB-ASSEMBLY |
Using a screwdriver, remove the spring shackle.
| 8. REMOVE REAR LEAF SPRING ASSEMBLY LH |
Remove the spring from the vehicle body.






