REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
| 1.
CHECK BRAKE SHOE LINING THICKNESS |
 |
Remove the hole plug (check), and check the shoe lining thickness through the hole.
- Minimum thickness:
- 1.0 mm (0.0394 in.)
If the thickness is less than the minimum, replace the shoe.
| 3.
DRAIN BRAKE FLUID |
 |
- NOTICE:
- Wash off brake fluid immediately if it comes in contact with any painted surface.
| 4.
REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
 |
Release the parking brake lever, and remove the drum.
- HINT:
- If the drum cannot be removed easily, perform the following procedures.
- Remove the hole plug (adjust) and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, compress the shoe adjuster by turning the adjusting wheel.