2014 Hilux · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH

C111497
  1. Using needle-nose pliers, remove the adjust lever tension spring and lever.


2. REMOVE BRAKE SHOES

C111498
  1. Using pliers, remove the shoe hold down springs, pins, front brake shoe and rear brake shoe.

  1. C113223
    Push the front or rear side of the wheel brake cylinder with the brake shoe. Then remove the side of the brake shoe opposite to the side of the cylinder being pushed. Finally remove the remaining side of the brake shoe.

    NOTICE:
    Be careful not to damage the cylinder dust boot.

  1. C113224
    Move one of the shoes downward and remove the shoe tension spring.

  1. C115339
    Remove the brake shoe front and rear side.

  1. Remove the strut set and return spring from the shoe.

  1. Remove the support clip from the strut set and return spring.

  1. C111502
    Using needle-nose pliers, disconnect the No. 3 parking brake cable from the parking brake shoe lever.


3. REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY

C111503
  1. Using a screwdriver, remove the C-washer and lever.


4. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY LH

C111505
  1. Using a union nut wrench, disconnect the brake line.

  1. Remove the 2 bolts and cylinder.


5. REMOVE REAR WHEEL BRAKE CYLINDER CUP
  1. Remove the 2 cylinder dust boots from the cylinder.

  1. Remove the 2 pistons and compression spring.

  1. Remove the 2 wheel cylinder cups from each piston.


6. REMOVE REAR BRAKE DRUM BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the cylinder.

← REMOVAL (from Jun 2011)INSPECTION (from Jun 2011) →