2014 Hilux · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE CONSOLE BOX ASSEMBLY
(Click here)

3. REMOVE SHIFT LEVER BOOT ASSEMBLY

G034215E03
  1. w/o Console Box:
    Remove the front seat, front door scuff plate, etc. and fold back the floor carpet so that the shift lever can be removed.

  1. Remove the 4 screws, 2 clips and shift lever boot.


4. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

G021695E01
  1. Cover the shift lever cap with a cloth.

  1. Press down on the shift lever cap and rotate it counterclockwise to remove it.

  1. Pull out the shift lever.


5. REMOVE NO. 1 ENGINE UNDER COVER

6. REMOVE NO. 2 ENGINE UNDER COVER

7. DRAIN MANUAL TRANSMISSION OIL
  1. Remove the drain plug and gasket to drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


8. REMOVE NO. 2 CROSSMEMBER SUB-ASSEMBLY

D033401E01
  1. Remove the 4 bolts, 4 nuts and frame crossmember.


9. REMOVE REAR PROPELLER SHAFT ASSEMBLY
(Click here)

10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)

11. DISCONNECT WIRE HARNESS
  1. Disconnect the back-up light switch connector and speedometer sensor connector.


12. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

G034217E01
  1. Remove the 2 bolts and disconnect the release cylinder.


13. REMOVE STARTER ASSEMBLY
(Click here)

14. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

B085193E03
  1. Support the transmission rear side with a support stand.

  1. Remove the 4 set bolts of the rear No. 1 engine mounting insulator.

  1. Remove the 4 bolts, 4 nuts and frame crossmember.


15. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

G034219E04
  1. Remove the 4 bolts and mounting insulator.


16. REMOVE STIFFENER PLATE

C121621E01
  1. Remove the 4 bolts and stiffener plate RH.

  1. Remove the 4 bolts and stiffener plate LH.


17. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

C112945E07
  1. Using a transmission jack, support the transmission.

  1. Remove the support stand from the rear side.

  1. Remove the 4 bolts and transmission.

← COMPONENTS (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →