Install the frame crossmember with the 4 bolts and 4 nuts.
Torque:
50 N*m{
510 kgf*cm
, 37 ft.*lbf
}
11.
ADD MANUAL TRANSMISSION OIL
Stop the vehicle on a level surface.
Remove the filler plug and gasket.
Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the filler plug opening. If the result is not as specified, add transmission oil.
Oil grade:
GL-4
Viscosity:
SAE 75W-90, 80W or 80W-90
Standard capacity:
2.2 liters (2.3 US qts, 1.9 Imp. qts)
NOTICE:
Too much or too little oil will lead to transmission problems.
After adjusting the oil level, drive the vehicle and check the oil level again.
Check for oil leakage when the oil level is low. If leakage is found, repair the area necessary to stop the leak. Replace damaged parts as necessary.
Install a new gasket and the filler plug.
Torque:
37 N*m{
377 kgf*cm
, 27 ft.*lbf
}
12.
INSTALL NO. 2 ENGINE UNDER COVER
Torque:
28 N*m{
286 kgf*cm
, 21 ft.*lbf
}
13.
INSTALL NO. 1 ENGINE UNDER COVER
Torque:
28 N*m{
286 kgf*cm
, 21 ft.*lbf
}
14.
INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY
Cover the shift lever cap with a cloth.
Press down on the shift lever cap and rotate it clockwise to install it.
HINT:
Apply MP grease to the tip of the shift lever.
15.
INSTALL SHIFT LEVER BOOT ASSEMBLY
Install the shift lever boot with the 4 screws and 2 clips.
w/o Console Box: Install the floor carpet, front seat, front door scuff plate, etc.