2014 Hilux · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedures for the RH and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT SPEED SENSOR LH

C113715
  1. Remove the bolt and speed sensor.

  1. Disconnect the 2 clamps.

  1. Remove the bolt and disconnect the speed sensor wire harness from the steering knuckle.


3. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

F042731E01
  1. Remove the bolt and disconnect the brake tube bracket from the steering knuckle.

  1. F050777E01
    Using SST, disconnect the brake tube from the disc brake cylinder.
    SST
    09023-00101  

  1. F050211E01
    Remove the 2 bolts and disc brake cylinder.


4. REMOVE FRONT DISC

5. REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)

F042729E01
  1. Using a screwdriver and hammer, remove the grease cap.

    NOTICE:
    Do not damage the axle hub.


6. REMOVE FRONT AXLE HUB NUT (for 4WD)

F042732E01
  1. Remove the cotter pin and lock cap.

  1. Remove the hub nut.


7. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH

C099158E01
  1. Remove the nut and disconnect the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.


8. DISCONNECT TIE ROD END SUB-ASSEMBLY LH

C113717E01
  1. Remove the cotter pin and nut.

  1. Using SST, disconnect the tie rod end from the steering knuckle.

    SST
    09628-62011  


9. DISCONNECT FRONT SUSPENSION LOWER ARM ASSEMBLY WITH ATTACHMENT LH

F050870E01
  1. Remove the 2 bolts and disconnect the front suspension arm from the steering knuckle.


10. DISCONNECT FRONT SUSPENSION UPPER ARM ASSEMBLY

F042736E01
  1. Remove the clip and nut.

  1. Using SST, disconnect the steering knuckle from the suspension upper arm.

    SST
    09628-62011  


11. REMOVE FRONT AXLE HUB DUST SEAL (for 4WD)

F042766E01
  1. Using a screwdriver and hammer, tap out the dust seal.


12. REMOVE KNUCKLE GREASE RETAINER CAP LH (for Pre-Runner)

F042756E01
  1. Using a screwdriver and hammer, remove the knuckle grease retainer inner.


13. REMOVE FRONT AXLE HUB ASSEMBLY

F042759E01
  1. Remove the 4 bolts, dust cover and axle hub from the steering knuckle.

  1. Remove the O-ring from the axle hub.

← COMPONENTS (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2013) →