2014 Hilux · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


1. INSTALL COUNTER GEAR FRONT BEARING

D026124E01
  1. Using SST and a press, press in the front bearing to the counter gear.

    SST
    09515-10010  

    NOTICE:
    Install it so that the snap ring groove of the bearing faces to the front side.


2. INSTALL NO. 2 COUNTER GEAR FRONT BEARING SNAP RING
  1. Select a snap ring that makes the clearance between the counter gear and snap ring to be within the specification.

    Standard clearance:
    0.1 mm (0.0039 in.) or less
    Mark
    Thickness
    A
    2.05 to 2.10 mm (0.0807 to 0.0827 in.)
    B
    2.10 to 2.15 mm (0.0827 to 0.0846 in.)
    C
    2.15 to 2.20 mm (0.0846 to 0.0866 in.)
    D
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    E
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    F
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)

  1. D026119E02
    Using a snap ring expander, install the snap ring.

← REMOVAL (from Jun 2011)INSTALLATION (from Aug 2012) →