2014 Hilux · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. REMOVE NO. 2 COUNTER GEAR FRONT BEARING SNAP RING

D026119E01
  1. Using a snap ring expander, remove the snap ring from the counter gear.


2. REMOVE COUNTER GEAR FRONT BEARING

D026121E01
  1. Using SST and a press, press out the front bearing from the counter gear.

    SST
    09950-00020  
    09950-60010   (09951-00220)
    09950-70010   (09951-07100)


3. INSPECT COUNTER GEAR

C086509E01
  1. Using a micrometer, measure the outside diameter of the counter gear as shown in the illustration.

    Standard outside diameter:
    29.984 to 30.000 mm (1.1805 to 1.1811 in.)

    Minimum outside diameter:
    29.984 mm (1.1805 in.)

    If the outside diameter is less than the minimum, replace the counter gear with a new one.

← COMPONENTS (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →