2014 Hilux · Service Manual BODY ELECTRICAL

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013


START DIAGNOSTIC MODE

HINT:
  1. Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.
  2. If the system cannot enter the diagnostic mode, replace the radio and display receiver assembly (Click here).

  1. Start the engine.

  2. C240185E01
    While pressing and holding the "AUDIO" or "MEDIA" switch, operate the light control switch: off → turn on → turn off → turn on → turn off → turn on → turn off.
    Text in Illustration 
    *a
    Example

  3. E222227
    Diagnostic mode starts and the "Service Menu" screen is displayed.


FINISH DIAGNOSTIC MODE
  1. There are 2 methods to end diagnostic mode. Use one of them.

    1. Turn the ignition switch off.

    2. Press and hold the "AUDIO" or "MEDIA" switch for 3 seconds.


FAILURE DIAGNOSIS

  1. E222228
    Touch the "Failure Diagnosis" button on the "Service Menu" screen.

  2. E222229
    The "Failure Diagnosis" screen is displayed.


SYSTEM CHECK

  1. E222230
    Touch the "System Check" button on the "Failure Diagnosis" screen.

  2. E222231
    The "System Check Mode" screen is displayed.


CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN)
  1. Read the system check result.

  2. E222234E01
    If the check result is "DETAIL", touch the displayed check result.
    Text in Illustration 
    *a
    Check Result

  3. E222238E01
    View the results on the "Unit Check Mode" screen and record them.
    Text in Illustration 
    *a
    Diagnostic Code

  4. When proceeding to view the results of another device, touch the "Back" button to return to the "System Check Mode" screen.

    HINT:
    To check the other items, repeat this procedure from the first step.


DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN)

  1. Clear DTC

    1. E222240
      Touch the "Code CLR" button for 3 seconds.

    2. Confirm that the check results are cleared.

      HINT:
      1. To clear the DTC for a specific device, clear the DTC using the "Unit Check Mode" screen.
      2. When clearing a DTC using the "Unit Check Mode" screen, touch the "Code CLR" button for 3 seconds.

  2. Recheck

    1. E222241
      Touch the "Recheck" button.

    2. E222242
      Confirm that all check results are "OK" when the check results are displayed. If a result other than "OK" is displayed, troubleshoot again.

      HINT:
      When a DTC is cleared using the "Unit Check Mode" screen, touch the "Back" button to return to the "System Check Mode" screen and perform this operation.

← TERMINALS OF ECU (from Aug 2013)DTC CHECK / CLEAR (from Aug 2013) →