C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage
Diagnostic trouble codes · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
DESCRIPTION
This is the power source circuit of the skid control ECU.The skid control ECU has a built-in brake actuator.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1241/41 |
When either of following is detected: 1. Both conditions continue for at least 10 seconds
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (ECU-IG NO. 2) |
Remove the ECU-IG NO. 2 fuse from the engine room relay block, junction block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. INSPECT BATTERY |
Check the battery voltage.
- Standard voltage:
- 11 to 14 V
Result Result
Proceed to
Battery voltage is normal (when using intelligent tester)
A
Battery voltage is normal (when not using intelligent tester)
B
Battery voltage is abnormal
C
|
|
||||
|
|
||||
| A | |
| 3. READ VALUE USING INTELLIGENT TESTER (ECU IG POWER VOLTAGE) |
Using the Data List, check for proper functioning of the ECU IG power voltage.
Skid control ECU Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
ECU IG Power Voltage
ECU power supply voltage / TOO LOW / NORMAL / TOO HIGH
TOO HIGH: more than 14.0 V
NORMAL: 10 to 14.0 V
TOO LOW: Below 10 V
-
Result Result
Proceed to
Display is NORMAL
A
Display is not NORMAL
B
|
|
||||
| A | ||
| ||
| 4. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY) |
![]() ![]() |
Disconnect the S2 ECU connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
S2-25 (IG1) - Body ground
10 to 14 V
|
|
||||
| OK | |
| 5. CHECK WIRE HARNESS (SKID CONTROL ECU - BODY GROUND) |
![]() ![]() |
Disconnect the S2 ECU connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
S2-2 (GND1) - Body ground
Below 1 Ω
S2-24 (GND2) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 6. CHECK IF DTC OUTPUT RECURS |
Clear the DTCs.
Drive the vehicle at approximately 30 km/h (19 mph) or more for 60 seconds or more.
Check for DTCs.
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||


