Speedometer Malfunction
Circuit diagnosis · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
The combination meter receives vehicle speed signals from the speedometer sensor via the direct line.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK VEHICLE SPEED SENSOR (OUTPUT SIGNAL) |
 |
Remove the combination meter assembly with the connector(s) still connected.
Using an oscilloscope, check the signal waveform of the meter.
Measurement Condition
Item
|
Content
|
Tester Connection
|
C25-5 (SI) - Body ground
|
Tool Setting
|
5 V/DIV., 20 msec./DIV.
|
Condition
|
Driving at approx. 20 km/h (12 mph)
|
Text in Illustration
*a
|
Component with harness connected (Combination Meter Assembly)
|
- OK:
- The waveform displayed is as shown in the illustration.
- HINT:
- As the vehicle speed increases, the wavelength shortens.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|
| 2. CHECK HARNESS AND CONNECTOR (VEHICLE SPEED SENSOR - COMBINATION METER ASSEMBLY AND BODY GROUND) |
 |
Disconnect the S3 speedometer sensor connector.
Disconnect the C25 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
C25-5 (SI) - S3-3 (SI)
|
Always
|
Below 1 Ω
|
C25-31 (MS5) - S3-1 (IG+)
|
Always
|
Below 1 Ω
|
S3-1 (IG+) - S3-2 (SE)
|
Always
|
10 kΩ or higher
|
S3-1 (IG+) - S3-3 (SI)
|
Always
|
10 kΩ or higher
|
S3-2 (SE) - S3-3 (SI)
|
Always
|
10 kΩ or higher
|
S3-2 (SE) - Body ground
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| REPLACE VEHICLE SPEED SENSOR |
|