2014 Hilux · Service Manual BODY ELECTRICAL

Speedometer Malfunction

Circuit diagnosis · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

The combination meter receives vehicle speed signals from the speedometer sensor via the direct line.

WIRING DIAGRAM

E225467E06

INSPECTION PROCEDURE


1. CHECK VEHICLE SPEED SENSOR (OUTPUT SIGNAL)
E224603E06
  1. Remove the combination meter assembly with the connector(s) still connected.

  1. Using an oscilloscope, check the signal waveform of the meter.

    Measurement Condition 
    Item
    Content
    Tester Connection
    C25-5 (SI) - Body ground
    Tool Setting
    5 V/DIV., 20 msec./DIV.
    Condition
    Driving at approx. 20 km/h (12 mph)
    Text in Illustration 
    *a
    Component with harness connected
    (Combination Meter Assembly)

    OK:
    The waveform displayed is as shown in the illustration.

    HINT:
    As the vehicle speed increases, the wavelength shortens.



NG
Go to step 2
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)

2. CHECK HARNESS AND CONNECTOR (VEHICLE SPEED SENSOR - COMBINATION METER ASSEMBLY AND BODY GROUND)
  1. Disconnect the S3 speedometer sensor connector.

  1. Disconnect the C25 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C25-5 (SI) - S3-3 (SI)
    Always
    Below 1 Ω
    C25-31 (MS5) - S3-1 (IG+)
    Always
    Below 1 Ω
    S3-1 (IG+) - S3-2 (SE)
    Always
    10 kΩ or higher
    S3-1 (IG+) - S3-3 (SI)
    Always
    10 kΩ or higher
    S3-2 (SE) - S3-3 (SI)
    Always
    10 kΩ or higher
    S3-2 (SE) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE VEHICLE SPEED SENSOR


← Entire Combination Meter does not Operate (from Aug 2013)Speedometer Malfunction (Aug 2012 – Jul 2013) →