2014 Hilux · Service Manual BODY ELECTRICAL

Driver Side Seat Belt Warning Light does not Operate

Circuit diagnosis · Vehicles built from Jun 2011

WIRING DIAGRAM

E111791E16

INSPECTION PROCEDURE


1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (BUCKLE SWITCH)
E110284E01
  1. Disconnect the F12 belt connector.

  1. Measure the resistance of the buckle switch.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened (ON)
    Below 1 Ω
    Seat belt is fastened (OFF)
    1 MΩ or higher



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (BELT - METER AND BODY GROUND)
  1. Disconnect the F12 belt connector.

  1. Disconnect the C25 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard Resistance:
    Tester Connection
    Specified Condition
    F12-1 - C25-11 (BKL)
    Below 1 Ω
    F12-2 - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY


← Warning Buzzer does not Sound (from Jun 2011)Seat Belt Warning Light for Passenger Seat does not Flash (from Jun 2011) →