2014 Hilux · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013


CHECK SPEEDOMETER
  1. Check the speedometer operation.

    NOTICE:
    1. Do not use worn, underinflated or overinflated tires, as the speedometer reading will be inaccurate.

    2. E229581E01
      For Australian speedometers, check that the meter indication is within the acceptable ranges specified for the ID number on the meter (for the location of the ID number, refer to the illustration).


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List.

      Reference (km/h, except Australia) 
      Standard Indication
      Acceptable Range
      20 km/h
      21 to 25 km/h
      40 km/h
      41.7 to 46.2 km/h
      60 km/h
      62.7 to 67.2 km/h
      80 km/h
      83.4 to 88.4 km/h
      100 km/h
      104.3 to 109.3 km/h
      120 km/h
      125.1 to 130.6 km/h
      140 km/h
      145.8 to 151.8 km/h
      160 km/h
      166.2 to 173.2 km/h
      180 km/h*
      186.9 to 194.5 km/h
      *: except 5L-E
      Reference (for Australia, ID No. N73, N76) 
      Standard Indication
      Acceptable Range
      20 km/h
      19.9 to 22.9 km/h
      40 km/h
      39.8 to 43.3 km/h
      60 km/h
      59.6 to 63.1 km/h
      80 km/h
      79.5 to 83.5 km/h
      100 km/h
      99.4 to 103.4 km/h
      120 km/h
      119.3 to 123.3 km/h
      140 km/h
      139.2 to 143.2 km/h
      160 km/h
      159.0 to 163.0 km/h
      180 km/h*
      178.9 to 182.9 km/h
      *: except 5L-E
      Reference (for Australia, ID No. N72) 
      Standard Indication
      Acceptable Range
      20 km/h
      20.6 to 23.6 km/h
      40 km/h
      41.3 to 44.8 km/h
      60 km/h
      61.9 to 65.4 km/h
      80 km/h
      82.5 to 86.5 km/h
      100 km/h
      103.2 to 107.2 km/h
      120 km/h
      123.8 to 127.8 km/h
      140 km/h
      144.4 to 148.4 km/h
      160 km/h
      165.0 to 169.0 km/h
      180 km/h*
      185.7 to 189.7 km/h
      *: except 5L-E
      Reference (for Australia, ID No. N74, N74-A, N77) 
      Standard Indication
      Acceptable Range
      20 km/h
      20.4 to 23.4 km/h
      40 km/h
      40.8 to 44.3 km/h
      60 km/h
      61.2 to 64.7 km/h
      80 km/h
      81.6 to 85.6 km/h
      100 km/h
      102.0 to 106.0 km/h
      120 km/h
      122.4 to 126.4 km/h
      140 km/h
      142.8 to 146.8 km/h
      160 km/h
      163.2 to 167.2 km/h
      180 km/h*
      183.6 to 187.6 km/h
      *: except 5L-E
      Reference (for Australia, ID No. N75, N79) 
      Standard Indication
      Acceptable Range
      20 km/h
      20.1 to 23.1 km/h
      40 km/h
      40.1 to 43.6 km/h
      60 km/h
      60.2 to 63.7 km/h
      80 km/h
      80.2 to 84.2 km/h
      100 km/h
      100.3 to 104.3 km/h
      120 km/h
      120.4 to 124.4 km/h
      140 km/h
      140.4 to 144.4 km/h
      160 km/h
      160.5 to 164.5 km/h
      180 km/h*
      180.5 to 184.5 km/h
      *: except 5L-E
      Reference (for Australia, ID No. N80) 
      Standard Indication
      Acceptable Range
      20 km/h
      20.7 to 24.7 km/h
      40 km/h
      41.4 to 45.9 km/h
      60 km/h
      62.1 to 66.6 km/h
      80 km/h
      82.8 to 87.8 km/h
      100 km/h
      103.6 to 107.6 km/h
      120 km/h
      124.3 to 129.3 km/h
      140 km/h
      145.0 to 150.0 km/h
      160 km/h
      165.7 to 170.7 km/h
      180 km/h*
      186.4 to 191.4 km/h
      *: except 5L-E
      Reference (for Australia, ID No. N78, N81) 
      Standard Indication
      Acceptable Range
      20 km/h
      21 to 25 km/h
      40 km/h
      42.0 to 46.5 km/h
      60 km/h
      63.0 to 67.5 km/h
      80 km/h
      84.1 to 89.1 km/h
      100 km/h
      105.1 to 109.1 km/h
      120 km/h
      126.1 to 131.1 km/h
      140 km/h
      147.1 to 152.1 km/h
      160 km/h
      168.1 to 173.1 km/h
      180 km/h*
      189.1 to 194.1 km/h
      *: except 5L-E
      Reference (mph) 
      Standard Indication
      Acceptable Range
      20 mph
      21.0 to 23.5 mph
      40 mph
      42.0 to 44.5 mph
      60 mph
      62.5 to 66.0 mph
      80 mph
      83.1 to 87.1 mph
      100 mph
      103.9 to 108.4 mph

    5. Check the deflection width of the speedometer indicator.

      Reference:
      Within 0.3°

      If the result is not as specified, the speedometer may have a malfunction.


CHECK OUTPUT SIGNAL OF VEHICLE SPEED SENSOR

E169412E05
  1. Check the output signal waveform

    1. Remove the combination meter, but do not disconnect the connector.

    2. Using an oscilloscope, check the waveform of the combination meter.

      Item
      Content
      Tester Connection
      C25-6 (+S) - Body ground
      Tool Setting
      5 V/DIV., 20 msec./DIV.
      Vehicle Condition
      Driving at approx. 20 km/h (12 mph)

      OK:
      Refer to the illustration.

      HINT:
      1. As vehicle speed increases, the wavelength shortens.
      2. If the result is not specified, the speedometer may have a malfunction.


CHECK TACHOMETER (w/ Tachometer)
  1. Check the tachometer operation.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List.

      Reference 
      Standard Tachometer Indication (rpm)
      Acceptable Range (rpm)
      Data in ( ) are for reference only
      700
      630 to 770
      1000
      (900 to 1100)
      2000
      (1850 to 2150)
      3000
      2800 to 3200
      4000
      (3800 to 4200)
      5000
      4800 to 5200
      6000*1
      (5750 to 6250)
      7000*2
      6700 to 7300
      *1: for 1TR-FE, 2TR-FE, 1GR-FE
      *2: for 1TR-FE
      If the result is not as specified, the tachometer may have a malfunction.


CHECK FUEL SUCTION WITH PUMP AND GAUGE OR FUEL TANK VENT TUBE SUB-ASSEMBLY

E169491E15
  1. Disconnect the F15 fuel suction with pump and gauge connector*1 or F13 fuel tank vent tube connector*2.
    *1: for 1TR-FE, 2TR-FE, 1GR-FE
    *2: for 1KD-FTV, 2KD-FTV, 5L-E

  1. Turn the ignition switch ON, and then check the position of the receiver gauge needle.

    OK:
    Fuel receiver gauge indicates E.

    If the result is not as specified, the combination meter may have a malfunction.

  1. Connect terminals 2 and 3 of the wire harness side connector.

  1. Turn the ignition switch ON, and then check the position of the receiver gauge needle.

    OK:
    Fuel receiver gauge indicates F.

    If the result is not as specified, the combination meter may have a malfunction.


CHECK FUEL WARNING LIGHT

E169491E15
  1. Disconnect the F15 fuel suction with pump and gauge connector*1 or F13 fuel tank vent tube connector*2.
    *1: for 1TR-FE, 2TR-FE, 1GR-FE
    *2: for 1KD-FTV, 2KD-FTV, 5L-E

  1. Turn the ignition switch ON, and then check that the fuel receiver gauge indicates E and that the fuel warning light turns on.

    OK:
    FUEL warning light turns on.

    If the result is not as specified, the combination meter may have a malfunction.


CHECK OIL PRESSURE WARNING LIGHT

  1. E169492E01
    for 1TR-FE, 2TR-FE, 1GR-FE, 1KD-FTV, 2KD-FTV:

    1. Disconnect the E4 switch connector.

    2. Connect terminal 1 of the wire harness side connector to the body ground.

    3. Turn the ignition switch ON, and then check that the oil pressure warning light turns on.

      OK:
      OIL PRESSURE warning light turns on.

  1. E177986E01
    for 5L-E:

    1. Disconnect the E4 switch connector.

    2. Connect terminal 1 of the wire harness side connector to the body ground.

    3. Turn the ignition switch ON, and then check that the oil pressure warning light turns on.

      OK:
      OIL PRESSURE warning light turns on.


CHECK BRAKE WARNING LIGHT

  1. E169418E04
    Check the parking brake warning light.

    1. Disconnect the P2 switch connector.

    2. Connect terminal 1 of the wire harness side connector to the body ground.

    3. Turn the ignition switch ON, and then check that the warning light turns on.

      OK:
      BRAKE warning light turns on.

      If the result is not as specified, the combination meter may have a malfunction.

  1. E169493E01
    Check the brake fluid level warning light.

    1. Disconnect the B2 switch connector.

    2. Connect terminals 1 and 2 of the wire harness side connector.

    3. Turn the ignition switch ON, and then check that the brake warning light turns on.

      OK:
      BRAKE warning light turns on.

      If the result is not as specified, the combination meter may have a malfunction.

  1. for 1KD-FTV (w/ VSC):
    Check the vacuum pump warning light.

    1. E173709E03
      Disconnect the B9 switch connector.

    2. Connect terminals 1 and 2 of the wire harness side connector.

    3. Turn the ignition switch ON, and then check that the brake warning light turns on.

      OK:
      BRAKE warning light turns on.

      If the result is not as specified, the combination meter may have a malfunction.

  1. for 1KD-FTV, 2KD-FTV, 5L-E (w/o VSC):
    Check the vacuum pump warning light.

    1. E169494E02
      Disconnect the B3 switch connector.

    2. Connect terminal 1 of the wire harness side connector to the body ground.

    3. Turn the ignition switch ON, and then check that the brake warning light turns on.

      OK:
      BRAKE warning light turns on.

      If the result is not as specified, the combination meter may have a malfunction.


CHECK FRONT PASSENGER SEAT BELT WARNING LIGHT (w/ Front Passenger Seat Belt Warning System)

  1. E169495E15
    Disconnect the F17 belt connector.

  1. Connect terminals 1 and 2 of the wire harness side connector.

  1. Turn the ignition switch ON, and then check that the warning light blinks.

    OK:
    Seat belt warning light for passenger side blinks.

    If the result is not as specified, the multi-display*1 or passenger seat belt warning light*2 may have a malfunction.
    *1: w/ Multi-display
    *2: w/o Multi-display

← DATA LIST / ACTIVE TEST (from Aug 2013)ON-VEHICLE INSPECTION (from Aug 2013) →