2014 Hilux · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL SHOULDER BELT ANCHORAGE PLATE COVER

B087816E03
  1. Install the plate cover as shown in the illustration.

    HINT:
    Make sure the plate cover is firmly set into the garnish's claws.


2. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

B084924E01
  1. Insert the tip of the adjuster to the pillar, and align the adjuster's bolt hole to the pillar's bolt hole.

  1. Install the bolt as shown in the illustration.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


3. INSTALL CENTER PILLAR GARNISH LH
  1. Attach the guide and clip to install the center pillar garnish.

  1. Connect the front seat belt shoulder anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Attach the 4 claws to install the front seat belt shoulder anchor cover.


4. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

NOTICE:
Do not disassemble the retractor.

  1. B084922E03
    w/o Pretensioner:
    Align the claws with the seat belt positioning holes and install the ELR of the seat belt with the bolt as shown in the illustration.

    Torque:
    4.8 N*m{ 49 kgf*cm , 42 in.*lbf }

  1. B120576E01
    w/ Pretensioner:
    Install the bolt and seat belt.

    Torque:
    4.8 N*m{ 49 kgf*cm , 42 in.*lbf }

  1. B114993
    w/ Pretensioner:
    Connect the pretensioner connector as shown in the illustration.

  1. B084920E02
    Extra cab and double cab:
    Install the anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. B085693E02
    Double cab:
    Install the anchor of the seat belt with the built-in bolt after installing the center pillar garnish lower.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSPECTION (from Jun 2011)INSTALLATION (Aug 2012 – Jul 2013) →