2014 Hilux · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Jun 2011 – Jul 2013


1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

C112662
  1. Install the clutch release cylinder with the 2 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }


2. CONNECT CLUTCH RELEASE CYLINDER FLEXIBLE TUBE

C112616
  1. Using a union nut wrench, connect the flexible tube.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

  1. Install the 2 way with the bolt.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. C112615
    Using a union nut wrench, install the flexible tube.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


3. INSTALL RELEASE CYLINDER HEAT INSULATOR

C112617
  1. Install the insulator with the bolt and nut.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }


4. BLEED AIR FROM CLUTCH PIPE LINE
(Click here)

5. CHECK FOR CLUTCH FLUID LEAKAGE

6. CHECK FLUID LEVEL IN RESERVOIR

Fluid:
Made
Fluid
for TSAM Made
SAE J1704 or FMVSS No. 116 DOT 4
except TSAM Made
SAE J1703 or FMVSS No. 116 DOT 3

← REASSEMBLY (Jun 2011 – Jul 2013)COMPONENTS (from Jun 2011) →