REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedures for RHD and LHD vehicles.
- The procedures listed below are for LHD vehicles.
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| 2.
REMOVE FRONT SEAT ASSEMBLY LH |
 |
Remove the front seat assembly (Click here).
| 3.
REMOVE FRONT SEAT INNER CUSHION SHIELD LH |
 |
- Remove the screw.
Detach the claw and guide.
- Pull the front seat inner cushion shield LH to detach the claw and remove the front seat inner cushion shield LH.
| 4.
REMOVE FRONT SEAT INNER BELT ASSEMBLY |
 |
Disconnect the connector and detach the 3 clamps.
- Roll up the front seat cushion cover LH.
Remove the nut and front seat inner belt assembly.
Remove the buckle cover.
| 5.
REMOVE FRONT SEAT CUSHION COVER LH |
 |
- Remove the front seat cushion cover LH.