2014 Hilux · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedures for RHD and LHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat assembly (Click here).


4. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

  1. B289612
    Remove the screw.

  1. Detach the claw and guide.

  1. B289613
    Pull the front seat inner cushion shield LH to detach the claw and remove the front seat inner cushion shield LH.


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY

B284021E01
  1. Disconnect the connector and detach the 3 clamps.

  1. B284020
    Roll up the front seat cushion cover LH.

  1. Remove the nut and front seat inner belt assembly.


6. REMOVE FRONT SEAT CUSHION COVER LH

  1. B284016E01
    Remove the front seat cushion cover LH.

← REMOVAL (Aug 2012 – Jul 2013)INSPECTION (from Jun 2011) →