DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Thoroughly clean all parts to be assembled.
- Before installing the parts, apply fresh engine oil to all sliding and rotating surfaces.
- Replace all gaskets and oil seals with new one.
| 1.
REMOVE VALVE LIFTER |
 |
Remove the valve lifter and adjusting shim.
- HINT:
- Arrange the valve lifters and shims in the correct order.
| 2.
REMOVE INTAKE VALVE |
 |
- Using SST, compress the valve spring and remove the 2 retainer locks.
- SST
- 09202-70020
(09202-00030)
Remove the spring retainer, valve spring, valve and spring seat.
- HINT:
- Arrange the valves, valve springs, spring seats and spring retainers in the correct order.
| 3.
REMOVE EXHAUST VALVE |
 |
- Using SST, compress the valve spring and remove the 2 retainer locks.
- SST
- 09202-70020
(09202-00030)
Remove the spring retainer, valve spring, valve and spring seat plate washer.
- HINT:
- Arrange the valves, valve springs, spring seat plate washers and spring retainers in the correct order.
| 4.
REMOVE VALVE STEM OIL SEAL |
 |
- Using needle-nose pliers, remove the oil seal.
| 5.
REMOVE COMBUSTION CHAMBER SUB-ASSEMBLY |
 |
- Using SST, remove the 4 combustion chambers (and shims).
- SST
- 09208-48010
- HINT:
- Arrange the combustion chambers (and shims) in the correct order.
| 6.
REMOVE SEMICIRCULAR PLUG |
 |
Remove the semicircular plug from the cylinder head.