INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) |
![]() ![]() |
Measure the resistance of the buckle switch.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Seat belt is unfastened
Below 1 Ω
1 - 2
Seat belt is fastened
1 MΩ or higher
| INSPECT OCCUPANT DETECTION SENSOR |
![]() ![]() |
Measure the resistance of the sensor.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
More than 147 N (15 kgf, 33 lbf) of force applied to occupant detection sensor
Below 100 Ω
1 - 2
No force applied to occupant detection sensor
1 MΩ or higher
| INSPECT FRONT SEAT INNER BELT ASSEMBLY (Passenger Side) |
![]() ![]() |
Measure the resistance of the buckle switch.
- HINT:
- Before performing the buckle switch check, perform the previous step (inspect occupant detection sensor) to make sure the occupant detection sensor is functioning normally.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Seat belt is unfastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor
Below 100 Ω
1 - 2
Seat belt is fastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor
1 MΩ or higher
| INSPECT PASSENGER SEAT BELT WARNING LIGHT ASSEMBLY |
![]() ![]() |
Check the illumination area of the seat belt warning light.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → 3 (IG)
Battery negative (-) → 2 (SW), 1(GND)
Illuminates





