2014 Hilux · Service Manual RESTRAINTS

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

B206000E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Seat belt unfastened
    Below 1 Ω
    1 - 4
    Seat belt fastened
    1 MΩ or higher

    If the result is not as specified, replace the inner belt assembly.


INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

B118978E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor
    Below 100 Ω
    1 - 2
    Seat belt is fastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor
    1 MΩ or higher

    If the result is not as specified, replace the inner belt assembly.


INSPECT OCCUPANT DETECTION SENSOR

E169498E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1- 2
    More than 147 N (15 kgf, 33 lbf) of force applied to occupant detection sensor
    Below 100 Ω
    1- 2
    No force applied to occupant detection sensor
    1 MΩ or higher

    If the result is not as specified, replace the occupant detection sensor (front seat cushion pad).

← REMOVAL (from Aug 2013)INSTALLATION (Jun 2011 – Jul 2012) →