DISASSEMBLY
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1.
REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
|
 |
- Detach the clamp.
Disconnect the connector.
Remove the screw and air conditioning amplifier assembly.
Text in Illustration
*1
|
Screw
|
| 2.
REMOVE BLOWER ASSEMBLY |
 |
- Remove the 3 screws and blower assembly.
| 3.
REMOVE QUICK HEATER ASSEMBLY (w/ PTC Heater)
|
 |
- Detach the 2 clamps.
Remove the 2 screws and quick heater assembly.
| 4.
REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
 |
- Remove the screw and heater radiator unit sub-assembly.
| 5.
REMOVE AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY |
 |
- Detach the 3 claws and remove the air mix damper control cable sub-assembly.
| 6.
REMOVE HEATER CONTROL CABLE SUB-ASSEMBLY |
 |
- Detach the 3 claws and remove the heater control cable sub-assembly.
| 7.
REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
 |
- Remove the 4 screws.
Detach the 3 claws and remove the cover.
- Detach the clamp.
Remove the No. 1 cooler evaporator sub-assembly from the case.
| 8.
REMOVE COOLER EXPANSION VALVE |
 |
- Using a 4 mm socket hexagon wrench, remove the 2 hexagon bolts.
Remove the cooler expansion valve and 2 O-rings from the cooler evaporator.
| 9.
REMOVE NO. 1 COOLER THERMISTOR
|
 |
- Remove the No. 1 cooler thermistor (front evaporator temperature sensor).