REASSEMBLY
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. INSTALL NO. 1 COOLER THERMISTOR |
![]() ![]() |
- NOTICE:
- If reusing the evaporator, do not insert the sensor at a location where the sensor was previously inserted. Insert the sensor within range C shown in the illustration.
Insert the No. 1 cooler thermistor (front evaporator temperature sensor) as shown in the illustration to install it.
| 2. INSTALL COOLER EXPANSION VALVE |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.
- Compressor oil:
- ND-OIL 8 or equivalent
Install the 2 O-rings to the cooler evaporator.
Install the cooler expansion valve.
Using a 4 mm socket hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
- Torque:
- 3.5 N*m{ 35 kgf*cm , 30 in.*lbf }
| 3. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
Install the No. 1 cooler evaporator sub-assembly to the case.
Attach the clamp.
Attach the 3 claws to install the cover.
Install the 4 screws.
| 4. INSTALL HEATER CONTROL CABLE SUB-ASSEMBLY |
Attach the 3 claws to install the heater control cable sub-assembly.
| 5. INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY |
Attach the 3 claws to install the air mix damper control cable sub-assembly.
| 6. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY |
Attach the 3 claws to install the heater control cable sub-assembly.
| 7. INSTALL QUICK HEATER AND ACCESSORY ASSEMBLY (w/ PTC Heater) |
Install the quick heater assembly with the 2 screws.
Attach the 2 clamps.
| 8. INSTALL BLOWER ASSEMBLY |
Install the blower assembly with the 3 screws.
| 9. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY |
Install the air conditioning amplifier assembly with the screw.
Connect the connector.
Attach the clamp.


