2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL NO. 1 COOLER THERMISTOR

E173257E01

NOTICE:
If reusing the evaporator, do not insert the sensor at a location where the sensor was previously inserted. Insert the sensor within range C shown in the illustration.

  1. Insert the No. 1 cooler thermistor (front evaporator temperature sensor) as shown in the illustration to install it.


2. INSTALL COOLER EXPANSION VALVE
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the 2 O-rings to the cooler evaporator.

  1. Install the cooler expansion valve.

  1. Using a 4 mm socket hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 35 kgf*cm , 30 in.*lbf }


3. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
  1. Install the No. 1 cooler evaporator sub-assembly to the case.

  1. Attach the clamp.

  1. Attach the 3 claws to install the cover.

  1. Install the 4 screws.


4. INSTALL HEATER CONTROL CABLE SUB-ASSEMBLY
  1. Attach the 3 claws to install the heater control cable sub-assembly.


5. INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY
  1. Attach the 3 claws to install the air mix damper control cable sub-assembly.


6. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
  1. Attach the 3 claws to install the heater control cable sub-assembly.


7. INSTALL QUICK HEATER AND ACCESSORY ASSEMBLY (w/ PTC Heater)
  1. Install the quick heater assembly with the 2 screws.

  1. Attach the 2 clamps.


8. INSTALL BLOWER ASSEMBLY
  1. Install the blower assembly with the 3 screws.


9. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY
  1. Install the air conditioning amplifier assembly with the screw.

  1. Connect the connector.

  1. Attach the clamp.

← REASSEMBLY (Aug 2012 – Jul 2013)INSTALLATION (Jun 2011 – Jul 2012) →