2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. A/C switch is ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)


2. REMOVE FRONT BUMPER COVER
(Click here)

3. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

E225069
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


4. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

E225070
  1. Remove the bolt and disconnect the air conditioning tube and accessory assembly from the cooler condenser.

  1. Remove the O-ring from the air conditioning tube and accessory assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


5. REMOVE HOOD LOCK ASSEMBLY
  1. for LHD:
    (Click here)

  1. for RHD:
    (Click here)


6. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY

  1. E233382
    Remove the 7 bolts and upper radiator support sub-assembly.


7. REMOVE COOLER CONDENSER ASSEMBLY

  1. E111650
    Remove the cooler condenser assembly.

← ON-VEHICLE INSPECTION (from Jun 2011)DISASSEMBLY (from Jun 2011) →