REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
|
 |
for Manual Air Conditioning System:
- Put protective tape around the center instrument cluster finish panel.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 10 claws and 4 clips.
- Detach the 4 claws and disconnect the air conditioner control.
Disconnect the connectors and remove the center instrument cluster finish panel.
for Automatic Air Conditioning System:
- Put protective tape around the center instrument cluster finish panel.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 8 claws and 4 clips.
Disconnect the connectors and remove the center instrument cluster finish panel.
| 2.
REMOVE COOLER SWITCH
|
 |
- Detach the 2 claws and remove the cooler switch (air conditioning switch).
| 3.
REMOVE NO. 2 HEATER CONTROL KNOB |
 |
Remove the No. 2 heater control knob as shown in the illustration.
| 4.
REMOVE HEATER CONTROL KNOB |
 |
Remove the heater control knob as shown in the illustration.
| 5.
DISCONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY |
 |
Detach the 2 claws and disconnect the air inlet damper control cable sub-assembly.
| 6.
DISCONNECT HEATER CONTROL CABLE SUB-ASSEMBLY |
 |
Detach the 2 claws and disconnect the heater control cable sub-assembly.
| 7.
DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (w/ Heater) |
 |
Detach the 2 claws and disconnect the air mix damper control cable sub-assembly.
| 8.
REMOVE AIR CONDITIONING CONTROL ASSEMBLY |
 |
Disconnect the connector and remove the air conditioning control assembly.