2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

  1. for Manual Air Conditioning System:

    1. B278367E01
      Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 10 claws and 4 clips.

    3. B278366
      Detach the 4 claws and disconnect the air conditioner control.

    4. Disconnect the connectors and remove the center instrument cluster finish panel.

  1. for Automatic Air Conditioning System:

    1. B278368E01
      Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 8 claws and 4 clips.

    3. Disconnect the connectors and remove the center instrument cluster finish panel.


2. REMOVE COOLER SWITCH

  1. E225767
    Detach the 2 claws and remove the cooler switch (air conditioning switch).


3. REMOVE NO. 2 HEATER CONTROL KNOB

E225816
  1. Remove the No. 2 heater control knob as shown in the illustration.


4. REMOVE HEATER CONTROL KNOB

E225817
  1. Remove the heater control knob as shown in the illustration.


5. DISCONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY

E225076
  1. Detach the 2 claws and disconnect the air inlet damper control cable sub-assembly.


6. DISCONNECT HEATER CONTROL CABLE SUB-ASSEMBLY

E225077
  1. Detach the 2 claws and disconnect the heater control cable sub-assembly.


7. DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (w/ Heater)

E226070
  1. Detach the 2 claws and disconnect the air mix damper control cable sub-assembly.


8. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
  1. Disconnect the connector and remove the air conditioning control assembly.

← REMOVAL (Jun 2011 – Jul 2012)REMOVAL (from Aug 2013) →