2014 Hilux · Service Manual TRANSMISSION

P0818 Driveline Disconnect Switch Input Circuit

Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012

DESCRIPTION

The ECM detects the signal from the transfer neutral position switch.
This DTC indicates that the transfer neutral position switch remains ON.
DTC Code
DTC Detection Condition
Trouble Area
P0818
Transfer neutral position switch remains ON while vehicle is running under following conditions for 30 sec. (2 trip detection logic):
  1. Vehicle speed is 25 km/h (16 mph) or more
  2. Transfer shift lever is on H
  1. Short in transfer neutral position switch circuit
  2. Transfer neutral position switch
  3. ECM

MONITOR DESCRIPTION

The ECM detects whether or not the transfer shift lever is in neutral by monitoring the signal from the transfer neutral position switch.
If the ECM detects that the transfer shift lever is in neutral under the following conditions, the ECM will conclude that there is a malfunction of the transfer neutral position switch:
  1. Transfer neutral position switch indicates that the transfer shift lever is in neutral.
  2. Transfer shift lever is in the H position.
  3. The vehicle is traveling at 25 km/h (16 mph) or more.
  4. The transfer neutral position switch has been ON for more than 30 seconds.
If all of the above conditions are detected, the ECM will conclude that there is a malfunction of the transfer neutral position switch, illuminate the MIL and store the DTC.

WIRING DIAGRAM

C120655E04

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND)
G037538E01
  1. Disconnect the T5 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Transfer Connection
    Specified Condition
    T5-2 - Body ground
    Below 1 Ω



NG
REPLACE COMBINATION METER
OK


2. INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
A110992E15
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
OK


3. INSPECT COMBINATION METER
  1. Check the A/T P indicator light.

    1. Disconnect the T5 switch connector.

    2. Turn the ignition switch ON.

    3. Connect the T5-1 terminal of the wire harness side connector to the body ground, and then check the A/T P indicator light.

      OK:
      A/T P indicator light illuminates.



NG
REPLACE COMBINATION METER
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR


← P0781 1-2 Shift (1-2 Shift Valve) (from Jun 2011)P0818 Driveline Disconnect Switch Input Circuit (from Aug 2012) →