The Transmission Control Module (TCM) and ECM perform 2-way communications with each other via the Controller Area Network (CAN). The TCM sends signals to the ECM concerning required engine rpm, required engine torques, warning indicators in the combination meter, DTCs and other data. The ECM sends signals to the TCM concerning engine rpm, opening angles of the throttle valve, temperature of the intake air and engine coolant, engine torques, and other data. If the TCM cannot communicate with the ECM, the TCM will conclude that there is a malfunction in the CAN system, illuminate the MIL and store a DTC.
DTC Code
DTC Detection Condition
Trouble Area
U0100
No communication from ECM for certain period of time (1-trip detection logic)
Open or short in TCM and ECM circuit
TCM
ECM
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
NOTICE:
If the ECM is replaced, the new ECM needs initialization.
1. CHECK ECM (+B VOLTAGE, E1 GROUND)
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E5-1 (+B) - Body ground
Ignition switch ON
11 to 14 V
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
E7-7 (E1) - Body ground
Always
Below 1 Ω
Text in Illustration
*a
Component with harness connected (ECM)
NG
GO TO ECD SYSTEM (ECM POWER SOURCE CIRCUIT) (Click here)
OK
2. CHECK TCM (IG2 VOLTAGE, E1 GROUND)
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
T38-6 (IG2) - Body ground
Ignition switch ON
11 to 14 V
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
T19-1 (E1) - Body ground
Always
Below 1 Ω
Text in Illustration
*a
Component with harness connected (TCM)
NG
GO TO ECU POWER SOURCE CIRCUIT
OK
3. CHECK HARNESS AND CONNECTOR (ECM - TCM)
Disconnect the E6 ECM connector.
Disconnect the T38 TCM connector.
Measure the resistance according to the value(s) in the table below.