P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION
The ECM detects the signal from the No. 1 transfer indicator switch (L4 position switch).This DTC indicates that the transfer L4 position switch remains ON.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P2772 |
|
|
MONITOR DESCRIPTION
The ECM monitors the transfer L4 position switch to determine when the transfer-case L4 gear is engaged. If the transfer-case L4 gears remain engaged under all of the following conditions, the ECM will conclude that there is a malfunction of the transfer L4 position switch:- The transfer L4 position switch indicates that the L4 transfer-case gears are engaged.
- Transfer-case shift lever is in the "H" position.
- Transfer-case output shaft rpm is between 750 and 3,000 rpm.
- The specified time period has elapsed.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH) |
![]() ![]() |
Remove the transfer indicator switch.
Measure the resistance of the switch when pushing the ball at the tip of the switch.
Tester Connection
Switch Condition
Specified Condition
1 - 2
Not pushed
10 kΩ or higher
1 - 2
Pushed
Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - ECM) |
![]() ![]() |
Disconnect the T4 switch connector.
Disconnect the E17 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E17-13 (L4) - T4-1 (L4)
Below 1 Ω
T4-2 (L4) - Body ground
Below 1 Ω
E17-13 (L4) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||


