2014 Hilux · Service Manual TRANSMISSION

L4 Position Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

The No. 1 transfer indicator switch (L4 position switch) detects the gear position of the transfer shift lever.
Moving the transfer shift lever to L4 turns the L4 position switch ON. Then the ECM cancels operation of the lock-up clutch.

WIRING DIAGRAM

C154998E32

INSPECTION PROCEDURE


1. INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
A110992E15
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
OK


2. CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - ECM AND BODY GROUND)
A107755E05
  1. Disconnect the T4 switch connector.

  1. Disconnect the E17 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E17-13 (L4) - T4-1 (L4)
    Below 1 Ω
    T4-2 (L4) - Body ground
    Below 1 Ω
    E17-13 (L4) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM


← P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance (from Jun 2011)REPLACEMENT (from Jun 2011) →