P0617 Starter Relay Circuit High
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
DESCRIPTION
While the engine is being cranked, positive (+) battery voltage is applied to terminal STA of the ECM. If the vehicle is being driven and the ECM detects the starter control signal (STA), the ECM concludes that the starter control circuit is malfunctioning. The ECM will illuminate the MIL and set a DTC.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0617 |
When conditions (a), (b) and (c) are met and battery (+B) voltage of 10.5 V or more is applied for 20 seconds. (a) Vehicle speed is greater than 20 km/h (12 mph) (b) Engine revolution is greater than 1,000 rpm (c) STA signal ON |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. READ DATA LIST (STARTER SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
Check the result when the ignition switch is turned to ON and START.
- Result:
Ignition Switch Position
STA Signal
Proceed to
ON → START
for A/T:
Display does not change from OFF → ON
A
ON → START
for M/T:
Display does not change from OFF → ON
B
ON → START
Display changes from OFF → ON
C
|
|
||||
|
|
||||
| A | |
| 2. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() ![]() |
Move the shift lever to the P or N position.
Disconnect the N1 Park/Neutral Position (PNP) switch connector.
Measure the resistance of the PNP switch.
- Standard:
Tester Connection
Shift Position
Specified Condition
4 (B) - 5 (L)
P or N
Below 1 Ω
4 (B) - 5 (L)
Except P or N
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT IGNITION SWITCH ASSEMBLY |
![]() ![]() |
Measure the resistance of the I6 ignition switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
5 - 7
LOCK
10 kΩ or higher
5 - 7
START
Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK IF DTC OUTPUT RECURS |
Clear the DTCs.
Drive the vehicle at more than 40 km/h (25 mph) for 20 seconds or more.
Connect the intelligent tester to the DLC3.
Turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTC.
- Result:
Display (DTC Output)
Proceed to
P0617 is output again
A
No DTC is output
B
|
|
||||
| A | ||
| ||


