INSTALLATION
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL STARTER ASSEMBLY |
Install the starter with the 2 bolts.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Install the starter wire to terminal 30 with the nut.
- Torque:
- 9.8 N*m{ 100 kgf*cm , 87 in.*lbf }
Connect the terminal cap.
Connect the starter connector.
| 2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY |
![]() ![]() |
Install the clutch release cylinder with the 2 bolts.
- Torque:
- 12 N*m{ 120 kgf*cm , 9 ft.*lbf }
| 3. INSTALL FRONT FENDER SEAL |
Install the fender seal with the 5 clips.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

