INSTALLATION
Removal / installation · Vehicles built from Aug 2013
| 1. INSTALL STARTER ASSEMBLY |
Temporarily install the starter assembly with the bolt.
Temporarily install the clutch flexible hose bracket with the bolt.
Tighten the 2 bolts.
- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Connect the starter wire with the nut.
- Torque:
- 9.8 N*m{ 100 kgf*cm , 87 in.*lbf }
Connect the terminal cap.
Connect the starter connector.
Attach the wire harness clamp and connect the wire harness with the bolt.
- Torque:
- 31 N*m{ 316 kgf*cm , 23 ft.*lbf }
| 2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY |
![]() ![]() |
Install the release cylinder with the 2 bolts.
- Torque:
- 12 N*m{ 120 kgf*cm , 9 ft.*lbf }
| 3. INSTALL FRONT FENDER SEAL |
Install the front fender seal with the 5 clips.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


