REASSEMBLY
Removal / installation · Vehicles built from Aug 2013
| 1. INSTALL STARTER CLUTCH SUB-ASSEMBLY |
![]() ![]() |
Apply high-temperature grease to the steel ball and install it to the starter clutch shaft hole.
Apply high-temperature grease to the return spring, starter idle gear retainer, starter idle gear pinion and starter crutch sub-assembly.
Install the return spring to the starter clutch sub-assembly.
Install the starter clutch sub-assembly, starter idle clutch roller, starter idle gear retainer and starter idle gear pinion to the starter drive housing assembly
| 2. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
Install the magnet starter switch assembly to the starter drive housing assembly with the 2 screws.
- Torque:
- 9.3 N*m{ 95 kgf*cm , 82 in.*lbf }
| 3. INSTALL STARTER ARMATURE ASSEMBLY |
Apply high-temperature grease to the bearings and install the starter armature assembly to the starter yoke assembly.
| 4. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
![]() ![]() |
Install the starter brush holder assembly to the starter yoke assembly.
Install the 4 starter brushes to the starter brush holder assembly.
Using a screwdriver, pull back the spring.
Install the brush to the brush holder.
- NOTICE:
- Check that the positive (+) lead wires are not grounded.
Install a new O-ring to the groove of the field frame.
Install the starter end frame with the 2 screws.
- Torque:
- 3.8 N*m{ 39 kgf*cm , 34 in.*lbf }
| 5. INSTALL STARTER YOKE ASSEMBLY |
Install a new O-ring to the groove of the starter yoke assembly.
Align the key of the starter yoke assembly with the groove of the magnet starter switch assembly.

Install the 2 through bolts.
- Torque:
- 9.3 N*m{ 95 kgf*cm , 82 in.*lbf }
Attach the wire harness clamp and connect the lead wire to terminal C with the nut.
- Torque:
- 5.9 N*m{ 60 kgf*cm , 52 in.*lbf }


