2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and front fender seal.


4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

G034223E01
  1. Remove the 2 bolts and disconnect the release cylinder.


5. REMOVE STARTER ASSEMBLY

  1. A302465
    Detach the wire harness clamp and remove the bolt to disconnect the wire harness.

  1. A302466
    Disconnect the starter connector.

  1. Disconnect the terminal cap.

  1. Remove the nut and disconnect the starter wire.

  1. A302467
    Remove the bolt and disconnect the clutch flexible hose bracket.

  1. Remove the bolt and starter assembly.

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →