2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE STARTER YOKE ASSEMBLY

  1. A074096E03
    Detach the wire harness clamp, remove the nut and disconnect the lead wire from terminal C.

  1. Remove the 2 through bolts, and then remove the starter yoke assembly together with the starter end frame.

  1. Remove the O-ring from the starter yoke assembly.


2. REMOVE STARTER BRUSH HOLDER ASSEMBLY

A062428E01
  1. Remove the 2 screws and starter end frame from the starter yoke assembly.

  1. Remove the O-ring from the starter yoke assembly.

  1. A062429E01
    Disconnect the 4 starter brushes from the brush holder assembly.

    1. Using a screwdriver, pull back the spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the starter brush holder assembly from the starter armature assembly.


3. REMOVE STARTER ARMATURE ASSEMBLY

NOTICE:
Turn the starter armature assembly and check that it turns freely.

  1. Remove the starter armature assembly from the starter yoke assembly.


4. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A074097E01
    Remove the 2 screws and starter drive housing assembly.

    NOTICE:
    Do not drop the starter idle gear pinion, starter idle gear retainer or starter idle clutch roller.


5. REMOVE STARTER CLUTCH SUB-ASSEMBLY

  1. A062427E09
    Remove the starter idle gear pinion, starter idle gear retainer, starter idle clutch roller, starter clutch sub-assembly and return spring from the starter drive housing assembly.
    Text in Illustration 
    *1
    Starter Idle Clutch Roller
    *2
    Starter Idle Gear Retainer
    *3
    Starter Idle Gear Pinion
    *4
    Return Spring
    *5
    Starter Clutch Sub-assembly
    *6
    Starter Drive Housing Assembly

  1. A115020E04
    Using a magnet hand, remove the steel ball from the starter clutch shaft hole.
    Text in Illustration 
    *1
    Magnet Hand

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →