2014 Hilux · Service Manual STEERING

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL VANE PUMP ASSEMBLY

  1. G028304E02
    Install the vane pump with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. G038598E02
    Connect the connector to the oil pressure switch.


2. CONNECT PRESSURE FEED TUBE ASSEMBLY

  1. G038602E02
    Install a new gasket and the pressure feed tube to the vane pump with the union bolt.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

    HINT:
    Make sure that the stopper of the pressure feed tube touches the front housing as shown in the illustration.


3. CONNECT RETURN HOSE

  1. G038601E02
    Connect the hose with the clip.


4. INSTALL FAN AND GENERATOR V BELT

  1. A097752E02
    Install the drive belt to the pulleys except the drive belt tensioner pulley.

  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

    NOTICE:
    1. The backside of the drive belt should face the tensioner pulley.
    2. Check that the drive belt is properly set to each pulley.

  1. G038479E01
    After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. ADD POWER STEERING FLUID
(Click here)

7. BLEED AIR FROM POWER STEERING SYSTEM

8. CHECK POWER STEERING FLUID LEVEL IN RESERVOIR

9. CHECK FOR FLUID LEAKS
← REASSEMBLY (from Jun 2011)COMPONENTS (from Jun 2011) →