REMOVAL
Removal / installation · Vehicles built from Jun 2011
- NOTICE:
- When using a vise, do not overtighten it.
- When installing the parts indicated by arrows, coat them with power steering fluid (Click here).
- When using a vise, do not overtighten it.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. DRAIN POWER STEERING FLUID |
| 3. REMOVE FAN AND GENERATOR V BELT |
| 4. DISCONNECT RETURN HOSE |
Remove the clip and disconnect the hose.

| 5. DISCONNECT PRESSURE FEED TUBE ASSEMBLY |
Remove the union bolt and disconnect the pressure feed tube from the vane pump.

Remove the gasket from the pressure feed tube.
| 6. REMOVE VANE PUMP ASSEMBLY |
Disconnect the connector from the power steering oil pressure switch.

Remove the 2 bolts and vane pump.

| 7. REMOVE VANE PUMP OIL RESERVOIR CAP SUB-ASSEMBLY |
| 8. REMOVE VANE PUMP OIL RESERVOIR SUB-ASSEMBLY |
Remove the 3 bolts and oil reservoir from the front vane pump housing.
Using a screwdriver, remove the O-ring from the oil reservoir.
