2014 Hilux · Service Manual STEERING

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. FIX VANE PUMP ASSEMBLY

G036582E01
  1. Using SST, fix the vane pump between aluminum plates in a vise, as shown in the illustration.

    SST
    09630-00014   (09631-00132)


2. REMOVE FLOW CONTROL VALVE

C084485E01
  1. Using a 27 mm socket wrench, remove the pressure port union from the front housing.

  1. Using a screwdriver, remove the O-ring from the pressure port union.

  1. Remove the flow control valve from the front housing.

  1. Remove the compression spring from the front housing.


3. REMOVE POWER STEERING OIL PRESSURE SWITCH
  1. Remove the oil pressure switch from the front housing.


4. REMOVE REAR VANE PUMP HOUSING

C084483E01
  1. Remove the 4 bolts and housing rear from the front housing.

  1. Remove the O-ring from the rear housing.


5. REMOVE SHAFT WITH PULLEY

C057767E01
  1. Using a screwdriver, remove the shaft snap ring from the shaft with pulley.

  1. Remove the shaft with pulley from the rear housing.


6. REMOVE VANE PUMP ROTOR
  1. Remove the 10 vane pump plates from the vane pump rotor.

    NOTICE:
    Be careful not to drop the vane plates.

  1. Remove the vane pump rotor from the front housing.


7. REMOVE VANE PUMP CAM RING

8. REMOVE FRONT VANE PUMP SIDE PLATE

C065368E01
  1. Remove the front side plate from the front housing.

  1. Remove the O-ring No. 1 from the side plate.

  1. C065369E02
    Remove the No. 2 O-ring from the front housing.


9. REMOVE VANE PUMP HOUSING OIL SEAL

G034363E01
  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

← REMOVAL (from Jun 2011)INSPECTION (from Jun 2011) →