REMOVAL
Removal / installation · Vehicles built from Jun 2011
- NOTICE:
- When using a vise, do not overtighten it.
- When installing the parts indicated by arrows, coat them with power steering fluid (Click here).
- When using a vise, do not overtighten it.
| 1. REMOVE NO. 2 ENGINE UNDER COVER (for 4WD) |
Remove the 4 bolts and under cover.
| 2. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD) |
Remove the 4 bolts and under cover.
| 3. REMOVE FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE |
Remove the 8 bolts and crossmember brace.
| 4. DRAIN POWER STEERING FLUID |
| 5. DISCONNECT OIL RESERVOIR TO PUMP HOSE |
Remove the clamp and disconnect the hose.

| 6. DISCONNECT PRESSURE FEED TUBE ASSEMBLY |
Using a union nut wrench, remove the union bolt and disconnect the pressure feed tube from the vane pump.

Remove the gasket from the pressure feed tube.
| 7. REMOVE VANE PUMP ASSEMBLY |
Remove the 2 nuts and vane pump.

Remove the O-ring.
