DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1.
FIX VANE PUMP ASSEMBLY |
 |
Using SST, fix the vane pump between aluminum plates in a vise, as shown in the illustration.
- SST
- 09630-00014
| 2.
REMOVE POWER STEERING SUCTION PORT UNION |
 |
Remove the 2 bolts and suction port union.
Remove the O-ring from the suction port union.
| 3.
REMOVE FLOW CONTROL VALVE |
 |
Using a 27 mm socket wrench, remove the pressure port union from the front housing.
Using a screwdriver, remove the O-ring from the pressure port union.
Remove the flow control valve from the front housing.
Remove the compression spring from the front housing.
| 4.
REMOVE REAR VANE PUMP HOUSING |
 |
Remove the 4 bolts and housing gear.
Remove the O-ring from the rear housing.
| 5.
REMOVE VANE PUMP ROTOR |
 |
Remove the 10 vane plates from the vane pump rotor.
- NOTICE:
- Be careful not to drop the vane plates.
Remove the vane pump rotor.
| 6.
REMOVE VANE PUMP CAM RING |
|
| 7.
REMOVE FRONT VANE PUMP SIDE PLATE |
 |
Remove the side plate from the front housing.
Remove the O-ring from the side plate.
- Remove the O-ring from the front housing.
| 8.
REMOVE VANE PUMP GEAR |
 |
Using a screwdriver, pry out the snap ring.
- HINT:
- Tape the screwdriver tip before use.
- Using a press, press the shaft (with gear and bearing) out of the front housing.
- Place a 12 mm socket wrench on the shaft.
Using SST and a press, press the shaft out of the gear.
- SST
- 09950-00020
| 9.
REMOVE VANE PUMP SHAFT BEARING |
 |
Using SST and a press, press the shaft out of the bearing.
- SST
- 09950-00020
- Using a snap ring expander, remove the snap ring from the shaft.
| 10.
REMOVE VANE PUMP HOUSING OIL SEAL |
 |
Using SST, remove the oil seal.
- SST
- 09319-60020
09506-35010