2014 Hilux · Service Manual STEERING

INSTALLATION

Removal / installation · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013


1. INSTALL VANE PUMP ASSEMBLY
  1. Coat a new O-ring with MP grease and install it to the vane pump.

  1. G034432E01
    Install the pump with the 2 nuts.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }


2. CONNECT PRESSURE FEED TUBE ASSEMBLY

  1. G035008
    Using a union nut wrench, connect the tube to the vane pump with a new gasket and the union bolt.

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


3. CONNECT OIL RESERVOIR TO PUMP HOSE

  1. G034430E01
    Connect the oil reservoir to the pump hose with the clamp.

    HINT:
    1. Install the pump side of the hose so that the paint mark faces the front of the vehicle. Align the reservoir tank side of the hose to the tank port rib.
    2. Make sure the clamp's claw on the pump side faces the front of the vehicle. Also make sure the clamp's claw on the reservoir tank side faces the top of the vehicle.


4. ADD POWER STEERING FLUID
(Click here)

5. BLEED AIR FROM POWER STEERING SYSTEM

6. CHECK POWER STEERING FLUID LEVEL IN RESERVOIR

7. INSPECT FOR FLUID LEAKS

8. INSTALL FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE
  1. Install the crossmember brace with the 8 bolts.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }


9. INSTALL NO. 1 ENGINE UNDER COVER (for 4WD)
  1. Install the engine under cover with the 4 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }


10. INSTALL NO. 2 ENGINE UNDER COVER (for 4WD)
  1. Install the engine under cover with the 4 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

← REASSEMBLY (from Jun 2011)INSTALLATION (from Aug 2013) →