2014 Hilux · Service Manual BODY

ADJUSTMENT

Removal / installation · Vehicles built from Jun 2011

HINT:

  1. B286201E01
    Centering bolts are used to mount the hood hinge to the vehicle body and hood. The hood cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts (with washers) when making adjustments.
  2. A bolt without a torque specification is shown in the standard bolt chart (Click here).

Text in Illustration 
*1
Centering Bolt
*2
Standard Bolt

1. ADJUST HOOD SUB-ASSEMBLY

  1. B276672
    Adjust the hood position.

    1. Loosen the 4 hinge bolts on the hood and adjust the hood position.

    2. Move the hood and adjust the clearance between the hood and front fender.

    3. Tighten the 4 hinge bolts on the hood after the adjustment.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. B283189
    Adjust the cushion rubbers so that the hood and fender are aligned.

    HINT:
    Raise or lower the front end of the hood by turning the cushion rubber.

  1. B286138
    Adjust the hood lock.

    1. Loosen the 3 bolts.

    2. Adjust the hood lock position so that the striker can enter it smoothly.

    3. Tighten the 3 bolts after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

← DISASSEMBLY (from Jun 2011)REASSEMBLY (from Jun 2011) →