2014 Hilux · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL TRANSMISSION WIRE

C113707
  1. Coat a new O-ring with the ATF, and install it to the transmission wire connector.

  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission wire connector.


2. CONNECT TRANSMISSION WIRE

C125285E02
  1. Connect the 7 connectors to the solenoid valves.

  1. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

    Torque:
    for bolt A:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    for bolt B:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    12 mm (0.472 in.) for bolt A
    36 mm (1.42 in.) for bolt B


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

D028692E01
  1. Coat a new O-ring with ATF and install it to the oil strainer.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

C153314E01

HINT:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install a new gasket and the oil pan with the 20 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }


5. INSTALL NO. 1 ENGINE MOUNTING INSULATOR REAR (for 1KD-FTV)

G034260E01
  1. Install the engine mounting insulator to the transmission with the 4 bolts.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }


6. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for 1KD-FTV)

C193827
  1. Install the frame crossmember to the engine mounting insulator with the 4 set bolts.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }

  1. Connect the ends of the frame crossmember to the vehicle with the 4 bolts and 4 nuts.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.


8. PERFORM INITIALIZATION
  1. Perform initialization (Click here).


9. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).

← INSTALLATION (Jun 2011 – Jul 2012)INSTALLATION (from Aug 2013) →